Print
In the bleak midwinter, frosty wind made moan,
Earth stood hard as iron, water like a stone;
Snow had fallen, snow on snow, snow on snow,
In the bleak midwinter, long ago.
- Christina Rossetti

As the days grow short and cold, and memories of warm afternoons sailing fade in the distance…here’s some tips on setting up your Martin 242 for winter storage!

1. One of the most important things specific to the Martin242 is taking care of the aft cockpit drain tubes. The “interestingly designed” geometry of these features means that water will pool down in the elbow when the boat is not in the water, which can cause the tubes to crack in freezing conditions. There’s various advanced solutions to this problem involving a lot of glass work to replace the existing tubes, but a much simpler one is to stick some rags in the aft drain tubes to drain water via capillary action.


2. Strip all the ropes off the deck so they don’t get moldy – mainsheet, pole downhaul, vang, cunningham, and traveler are relatively easy. Furling line is a bit trickier because you’ll have to re-wind the furling barrel if you unspool it, you could consider just coiling the end and hanging it off the pulpit to make your life easier.

3. Attach tracer lines to halyards with bowline knots so all the halyards can get sent up the mast and not bang all winter or get as moldy. Also protects them from UV (if the sun ever does come out).

4. Take your sails home to stay dry all winter. For those with living arrangements involving restricted square footage due to astronomical property values in BC, I find under the kitchen table works well. Partners don’t complain too much when you explain the thrill of winning the first race of the season because your sails stayed nice and dry. Life jackets, random hats and gloves kicking around the bilge, expensive GPS instruments – get those off the boat too.

5. If your yacht club or marina allows you to plug in somewhere – a heater and even dehumidifier if possible inside the cabin is great to keep the boat nice and dry inside. Even a low-draw marine fan to keep some air moving is a good option if you don’t want to burn too much power.

6. Take any old gasoline you have lying around in jerry cans & dispose properly. In Vancouver some of the return-it depots will take old gas (in a proper container) and give you a credit to purchase a new jerry can.

7. Run the outboard engine until the fuel line and carburetor are mostly dry (I actually try to do this every time I use the engine so the little bit of fuel doesn’t leak inside the boat). Better if you can take the outboard right off the boat and store it somewhere nice and warm and dry for the winter.

8. Drain the engine carb if possible by loosening off the carb drain screw so the gas doesn't turn to gel and then harden over the winter and gum up the carb: big $ to get it cleaned out professionally (see picture for example, although every engine is probably slightly different).

image credit to practical boat owner

9. Make sure the boat is properly seated on the trailer.

10. Check for leaks during the winter and seal them in the spring or on dry days.

One other option (this is what we do on Back in Black) is to take the mast down, rest it over the pushput & pulpit, and tarp the whole thing.

Our boat has some nagging leaks in a few spots, and there is usually some water that runs down the mast no matter how well you try to seal this up – so this option usually keeps the boat nice and dry. Taking the mast up and down is pretty fast if you use the Fleet 1 gin poles. The other advantage of this method is that you should likely be dropping the mast at least once a year to inspect it and do some maintenance anyways:
Happy Winter!